Nissan Skyline R32 intake manifold ASSY removal and installation
 
Nissan Skyline GT R32 Intake Manifold ASSY Removal and Installation
 
Additional work required: Removal and Installation
•  Collector ASSY
•  Throttle chamber
•  ECCS harness connector and all hoses
•  Water outlet hose
•  Blowby hose
 
[Point 1] Nissan Skyline R32 intake manifold ASSY bolt and nut removal and installation
 
Nissan Skyline GT R32 Intake Manifold ASSY Removal and Installation
 
Removal
 
•  Removal is the reverse of order shown in the figure on left. 
 
Installation
 
•  Installation is performed in order shown in figure. Tighten in gradual steps to uniform tightness.
 
 

Length: Number of bolts

Installation location

Bolt length below head mm (in)

30 (1.18): (4)

(3), (5), (6), (8)

60 (2.36): (5)

(1), (4), (10), (12), (14)

65 (2.56): (6)

(7), (8)

 
Tightening torque: 16-21 Nm (1.6 - 2.1 kg-m, 12-15 ft-lb)
 
[Point 2] Nissan Skyline R32 air drain plug
 
Nissan Skyline GT R32 Intake Manifold ASSY Removal and Installation
 
•  Perform when engine is cool. 
WARNING:
Never remove the air drain plug when engine is warm, because hot water may escape and cause injury.
•  When pouring coolant into engine, always remove air drain plug to allow air within engine to escape. (This prevents overheating.)
CAUTION:
Be careful not to strip screw threads by over-torquing the air drain plug.
 
Tightening torque: 7 - 8 Nm (0.7 - 0.8 kg-m, 5.1 - 5.8 ft-lb)