Nissan Skyline R32 fuel gauge ASSY
 
Nissan Skyline GT-R32 fuel gauge ASSY
 
(1) Nissan Skyline R32 fuel gauge ASSY removal and installation
 
Additional work required:
• Remove: Fuel pressure relief, internal pressure relief inspection hole cover Fuel gauge unit Fuel pump harness connector Fuel hose (return, feed) 
CAUTION:
• Install gauge unit with care.
• Do not touch float and arm to prevent them from bending.
• Do not bend or twist harness.
 
Nissan Skyline GT-R32 fuel gauge ASSY
 
[Point 1] Fuel gauge ASSY removal and installation
 
Removal
• Attach alignment marks to the fuel gauge ASSY and fuel tank and then remove the cap.
• Raise fuel gauge ASSY, remove 2 hoses in tank (marked section is outlet side), fuel pump harness connector and detach fuel gauge ASSY.
CAUTION:
Be especially careful not to damage fuel gauge ASSY.
 
Installation
• Check marking on hose inside tank and connect fuel gauge ASSY.
• Check that fuel gauge ASSY and fuel tank alignment marks are positioned correctly and tighten cap.
 
Tightening torque : 30-35 Nm (3.1 - 3.6 kg-m. 22 - 26 ft-lb)
 
Nissan Skyline GT-R32 fuel gauge ASSY
 
(2) Nissan Skyline R32 fuel gauge ASSY inspection (T) float inspection
• Place the float at the F (lever upper side) and E (lever down side) positions and check the resistance.
  

Float position

F position

E position

Inspection terminal

(4) – (5)

Approx. 6Ω

Approx. 80 Ω

  

Nissan Skyline GT-R32 fuel gauge ASSY
 
2 Nissan Skyline R32 low fuel warning lamp sensor inspection
• Connect a 12V - 3.4 W test lamp or equivalent.
• Wash sensor with gasoline or white gasoline and check that lamp does not light after approximately 3 minutes have elapsed.
• Remove sensor from gasoline or white gasoline and check that lamp lights within 3 minutes.