Nissan Skyline R32 front door window and regulator removal and installation
 
(1) 2-door Sports Coupe
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
[Point 1] Nissan Skyline R32 door window adjustment
• Door window fitting can basically be adjusted by moving window in four directions as shown below.
1 Window position (front-end down, rear-end down) 
2 Fore and aft adjustment of window 
3 Vertical adjustment of window (upper limit) 
4 Right and left adjustment of window (inward or outward inclination)
• Perform adjustment at the positions shown below.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
Adjustment work
 
• To adjust door window position, proceed as follows:
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
1 Window position adjustment
Remove and install: Body side weatherstrip (Part not shown)
NOTE:
Perform this position adjustment simultaneously with fore-aft adjustment in step (2).
• With window raised, loosen securing bolts C, D, ET and F, and adjust inclination of window using bolts С and D so that a uniform clearance will be obtained between window and retainer at positions A and B.
 
Window front end down: Raise adjustment bolt С using bolt D as supporting point.
Window rear end down: Raise adjustment bolt D using bolt С as supporting point.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
2 Fore-aft adjustment of window
• Loosen bolts [C, D, E, and F shown in step (1) above] and slide regulator in fore-aft direction so that clearance between rear end of window and retainer meet standard shown at left, then temporarily secure bolts by tightening nuts.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
• When adjusting, slightly lower window to create clearance between door side stopper and window side stopper. 
NOTE: 
Do not lower window excessively.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
3 Vertical adjustment of window
• With window fully closed, adjust height of door window stoppers (door side) (a) and (b) so that retainer lower end and window top end positions meet specification shown at left, then secure stoppers with nuts.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
4 Right and left adjusting of window • Use lower two of four adjusting bolts. 
NOTES:
(1) Rotate adjusting bolt in CW direction, and end of window will move outward.
Rotate adjusting bolt in CCW direction, and end of window will move inward.
(2) Slightly lower window, like in the case of fore-aft adjustment, to create a clearance between door side stopper and window side stopper.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
• Loosen nuts (front and rear), and loosen adjusting bolt and tilt window fully inward until adjusting bolt flange contacts inner panel.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
• With door fully closed in the above-mentioned position, tighten adjusting bolts a few turns until inside of window lightly contacts retainer.
NOTE:
Evenly tighten front and rear adjusting bolts.
 
Nissan Skyline GT-R32 Front door window and regulator removal and installation
 
• After completing adjustment, tighten lock nut securely.
NOTE:
When tightening lock nut, hold adjusting bolt using standard screwdriver to prevent rotation.