Nissan Skyline R32 front door lock and remote control removal and installation
 
(1) 2-door Sports Coupe
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
[Point 1] Inside handle rod adjustment
• Fix door lock and inside handle, and adjust bell crank in direction of arrow shown at left to eliminate rod play, then secure with screws.
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
[Point 2] Outside handle rod adjustment
• Rotate bushing so that clearance between bushing and rod meets specification shown at left. 
NOTE:
Clearance must be greater than 0 mm (0 in), or outside lever must be free when not being operated.
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
[Point 3] Outside handle single part removal
 
Removal
 
• Completely close window.
• Disconnect key cylinder rod and outside handle rod connections,
• Remove two nuts and remove outside handle.
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
[Point 4] Nissan Skyline R32 key cylinder removal and installation
 
Removal
 
• Insert tip of small standard screwdriver into clearance between clip and key cylinder to disengage clip, and remove key cylinder.
 
Installation
 
• Install clip to key cylinder case, and then insert key cylinder.
 
Nissan Skyline GT-R32 front door lock and remote control removal and installation
 
[Point 5] Nissan Skyline R32 door lock switch removal
Remove and install: Inside and outside handle rods, key cylinder rod (Part not shown)
• Remove rod, and remove door lock assembly screws (three) and door lock switch bolt (one), and then remove door lock assembly.
• Remove screws (two) to separate door lock assembly from door lock switch.
NOTE:
Door lock switch cannot be removed from door lock assembly if the assembly Is installed on vehicle. Be sure to remove door lock switch together with door lock assembly.