Nissan Skyline R32 rear window molding
 
Nissan Skyline GT-R32 rear window molding
 
Nissan Skyline GT-R32 rear window molding
 
[Point 1] Nissan Skyline R32 upper molding removal and installation
1 Remove lower molding securing screws, and remove molding from body. 
2 Remove corner molding clips, and remove corner molding from fastener. 
3 Remove upper molding by lifting its end up. 
4 Cut sealant at glass end portion, remove faster and clean panel surface. 
5 Bond fastener to body using double-faced adhesive tape, then apply primer to panel and molding leg portion.
6 Pack sealant between glass and body so that molding leg can be bonded securely.
 
Nissan Skyline GT-R32 rear window molding
 
7 Bond upper molding and joint molding using sealant to make up sub assembly. 
8 Squeeze upper molding sub assembly into fastener. 
9 Fit clip into corner molding, and fit corner molding to upper molding, then tap molding until it fits snugly into fastener. 
10 Fix lower molding using screws. 
NOTE:
Repair panel surface by coating if scratched while cutting sealant.