Nissan Skyline R32 windshield molding
 
Nissan Skyline GT-R32 windshield molding
 
Nissan Skyline GT-R32 windshield molding
 
[Point 1] Nissan Skyline R32 side molding removal and installation
 
Removal
 
1 Using standard screwdriver with its end portion bent as shown, disengage fastener from side molding by sliding lower two side molding clips.
NOTE:
Be sure to apply cushioning cloth under screwdriver to prevent glass from being damaged.
 
Nissan Skyline GT-R32 windshield molding
 
2 Remove side molding from fastener by pulling out lower end of molding.
 
Nissan Skyline GT-R32 windshield molding
 
Installation
 
1 Fit clip into side molding as shown at left.
NOTE:
Four different clips are used; Pay attention not to confuse clips.
 
Nissan Skyline GT-R32 windshield molding
 
2 Fit upper end of side molding into upper molding, and tap side molding clip portion with hand until clip fits in fastener with a snap.
NOTE:
Do not apply undue force when tapping. If difficult to fit, change clip position slightly.
 
Nissan Skyline GT-R32 windshield molding
 
[Point 2] Nissan Skyline R32 upper molding removal and installation
1 After removing side molding, pull out upper molding by lifting its end up. 
2 Cut sealant at end of glass, and clean panel surface after removing fastener. 
3 Bond fastener to body using double-faced adhesive tape, then apply primer to panel and molding leg portions. 
4 Pack sealant between glass and body so that molding leg can be bonded securely. 
5 Squeeze upper molding into position. 
NOTE: 
Repair panel surface if scratched when cutting sealant.